System Settings >> Remote Access Control

You can use this page to set remote access control to the WFilter system.

Settings

1. Allow Remote Access

You can access WFilter console from other computers only when "Allow Remote Access" is enabled.

2. Limit Remote IP address

If enabled, only IP addresses in the "Allowed IP Address List" can access WFilter.

3. Relogin if no operation for N seconds.

Operators will be asked to relogin if no operation for N minutes. 0 for no check of time out.

Notice

  1. One IP address per line. For example: 192.168.1.10
  2. To enable remote access, please also make sure the firewall program in the WFilter computer allow incoming connections to the WFilter port(default: tcp 9090).